Dual Articulating Head Rest recall in Canada: May not stay in place
In plain language
This recall involves the Dual Articulating Head Rest, model BF753. It is being recalled because it may not stay in place or lock during a patient procedure. This could result in injury to the patient or a procedural delay. Contact the manufacturer for more information.
What to do
- Contact the manufacturer, Steris Corporation, for additional information.
Get alerts for recalls like this
Get email alerts when new recalls affect products in this category.
Affected products
Dual Articulating Head Rest
Model: BF753
Why this matters
Injury risk due to product not staying in place
Do I have this product?
This recall only applies to specific products. Follow the steps below to check.
- 1
Check the product name
Make sure your product name matches one of the affected products listed above.
- 2
Check the model number
Model numbers are typically on the product label or packaging.
Affected models: BF753
If your product matches one or more of the details above, it may be affected by this recall.
If your product does not match these details, it is not affected by this recall.
When in doubt, always check the official notice.
Frequently Asked Questions
Why was this product recalled?
Injury risk due to product not staying in place
What should consumers do?
Contact the manufacturer, Steris Corporation, for additional information.
Where was the product sold?
This product was sold in Canada. For specific retailers or distribution areas, please check the official recall notice linked on this page.
Is there a health risk?
Yes, there may be a health risk. Injury risk due to product not staying in place
When was this product recalled?
This product was recalled on December 22, 2023.
Is the Steris Corporation brand affected by this recall?
Yes, Steris Corporation products are affected by this recall. This recall involves the Dual Articulating Head Rest, model BF753. It is being recalled because it may not stay in place or lock during a patient procedure. This could result in injury to the patient or a procedural delay. Contact the manufacturer for more information.